If the water tank empties, again you will need to unplug your mop before refilling it.
Then you can change the cleaning pad or mophead. If you need to change the cleaning pad, unplug the mop and wait 2 or 3 minutes for the mop to cool. When one side of the cleaning pad gets dirty, quickly flip the mophead to the other side to continue mopping your floor. If you are cleaning laminate or hardwood floors, move the mop in the same direction as the grain. The awesome thing about the Shark Steam Mop is that it works on any type of floor. Clean Your FloorsĬlean the floors with forwards and backwards motion. Press it three times for the scrub setting. Unwrap the cord and plug it into a 120-volt outlet. Pull out the cord of your steam mop by pulling the quick-release cord holder. It’s meant for deep cleaning heavily trafficked areas and will also sanitize the floor. It will cut through the dirt and grime allowing it to be removed. This setting is used for tough cleaning, stuck-on messes, and stains. Intended Surface: Tile, Stone, Linoleum Carpet with a carpet glider May be used carefully on hardwood floors but is not intended for continuous use.Activate: Press the on/standby button three times.It will loosen small messes from the floor and is best used for moderately and heavily trafficked floors. This setting is used for everyday cleaning. Intended Surface: Hardwood, Marble, Tile, Stone.Activate: Press the on/standby button two times.It loosens and lifts light dirt while sanitizing the floor. This setting is for light cleaning and dusting. Intended Surface: Laminate, Bamboo, Hardwood, Marble.Activate: Press the on/standby button once.The dust setting is for light cleaning, mop is for everyday cleaning, and scrub is for tough cleaning and messes that are stuck to the floor. The Shark Steam Mop has three settings namely dust, mop, and scrub.
Make sure to remove all the dirt and debris that might scratch the floor when you mop it. Sweep Your Floorsīefore you use your Shark Steam Mop, you will need to sweep or vacuum the floor. Be careful not to overfill it to prevent the steam mop from dripping while you use it. To remove the cap, turn it counterclockwise. Now snap the mophead into the base.įill the water tank with water. Use the quick fasteners at the top to secure it in place. Slide the mophead into the pad pocket using the lavender loop on the side of the cleaning pad. Push it past the line on the pole.įasten the handle to the body with the large screw provided and use a screwdriver to tighten it. Insert the front side of the handle into the body of the steam mop.
#SHARK STEAM AND SCRUB HOW TO#
Follow your Shark Steam Mop instruction manual for detailed directions on how to assemble your shark steam mop.
0 kommentar(er)
